Securesight VL1 Manual do Utilizador descarregar pdf (Página 21)

• Pressing the SET and MODE button together to enter

TEST MODE, the LCD will display the word

“

t E S t ”.

• Whilst in test mode, each time the PIR sensor is triggered a

red indicator behind the PIR lens will flash to indicate a

trigger. Walk around the coverage area to determine if your

camera is suitably mounted.

• Adjust the position of your VL1 if necessary and repeat

testing until the desired coverage area is achieved.

• When you have completed the coverage area testing, press

the MODE and SET button together again to leave the

TEST MODE.

• The VL1 will start a 60 seconds count down again.

• Alternatively, when you have finished testing if you leave

the VL1 for approximately 5 minutes it will automatically

begin the 60 seconds count down.

• Please leave the coverage area within 60 seconds to avoid

being photographed or videoed.

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 37 38

Sem comentários

Securesight VL1 Manual do Utilizador Página 21