Securesight VL1 Manual do Utilizador descarregar pdf (Página 16)

• Ensure you connect your VL1 in accordance with the wiring

diagram. Failure to do so may result in damage to your VL1

and will void your warranty.

• We recommend using a supply that you can switch off if

required. Once wired correctly, turn on the mains supply.

• When connected the VL1 lamp will turn on for

approximately 60 seconds whilst self-testing. It is then

ready for operation and will begin recording images each

time the motion sensor is triggered.

Replacing the halogen lamp if faulty

CAUTION your lamp will be very hot.

• Always disconnect the power to your VL1 before opening.

• Release the floodlight screw to open the floodlight cover.

• Carefully remove the Halogen lamp – it may be HOT.

• Insert a new Halogen lamp making sure you do not touch

the lamp with bare skin. Halogen Lamp : Max 500W R7S

• Close the floodlight cover and screw together carefully.

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 37 38

Sem comentários

Securesight VL1 Manual do Utilizador Página 16